minifinder protocol
TrackeraX decodes the minifinder protocol on port 6062. These are the devices that use it, the data it reports and the commands you can send to them.
- Port
- 6062
- Models
- 21
- Brands
- 3
Devices that use minifinder
- MiniFinder EV-07
- MiniFinder EV-07P
- Eview EV-07S
- Eview EV-07W
- Eview EV-601
- Eview EV-602
- Eview EV-603
- Eview EV-606
- Eview EV07P
- MiniFinder GPS668
- MiniFinder Atto
- No brand MiniFinder Pico
- MiniFinder SaR-mini
- MiniFinder TE-207
- MiniFinder TE200
- VisionOneGPS V1G-FT4G
- VisionOneGPS V1G-MB3G
- VisionOneGPS V1G-MTP3G
- VisionOneGPS V1G-MTP4G
- VisionOneGPS V1G-OBD4G
- VisionOneGPS V1G-PT3G
Commands you can send from TrackeraX
Available from the web platform and the apps. The custom command sends any text the device firmware accepts.
- Set time zone
setTimezone - Voice monitoring
voiceMonitoring - Overspeed alarm
alarmSpeed - Movement alarm
movementAlarm - Vibration alarm
alarmVibration - Fall alarm
alarmFall - AGPS
setAgps - Indicator
setIndicator - Power saving mode
modePowerSaving - Deep sleep mode
modeDeepSleep - SOS number
sosNumber - Custom command
custom
Data reported by the minifinder protocol
Parameters the server decodes from this protocol. In TrackeraX you turn them into sensors, alerts and reports. Each model reports the ones its firmware and wiring allow.
- Battery level
batteryLevel - Charging
charge - HDOP
hdop - GSM signal
rssi - Satellites
sat - Visible satellites
satVisible
Alarms the protocol can report
- Fall
fallDown - Fault
fault - Geofence
geofence - Low battery
lowBattery - Movement
movement - Overspeed
overspeed - SOS
sos