JMAK protocol devices on TrackeraX
The JMAK protocol devices is a GPS tracker that works with TrackeraX over the jmak protocol on port 6259. From the platform it accepts custom commands.
Technical sheet
- Brand
- JMAK
- Model
- JMAK protocol devices
- Protocol
- jmak
- Port
- 6259
How to connect it to TrackeraX
- Insert a SIM card with mobile data and set the APN of your carrier on the device.
- Set the server to the domain of your TrackeraX platform and the port 6259 (jmak protocol).
- Create the device in TrackeraX with its IMEI or identifier and choose the JMAK protocol devices model.
- Wait for the first position and turn the parameters above into sensors and alerts.
The exact commands to set the APN and server depend on the firmware: check the manufacturer's manual or ask our support team.
Commands you can send from TrackeraX
Available from the web platform and the apps. The custom command sends any text the device firmware accepts.
- Custom command
custom
Data reported by the jmak protocol
Parameters the server decodes from this protocol. In TrackeraX you turn them into sensors, alerts and reports. Each model reports the ones its firmware and wiring allow.
- Battery voltage
battery - Driver ID (RFID / iButton)
driverUniqueId - Fuel
fuel - Fuel consumption
fuelConsumption - Fuel used
fuelUsed - HDOP
hdop - Engine hours
hours - Ignition
ignition - OBD odometer
obdOdometer - OBD speed
obdSpeed - Odometer
odometer - Mobile operator
operator - RPM
rpm - GSM signal
rssi - Satellites
sat - Throttle
throttle - VIN
vin
Numbered inputs and sensors
- Counters (count1, count2…)
- Inputs (in1, in2…)
- Outputs (out1, out2…)
Protocol-specific attributes
autonomy · backup · canStatus · eventName · eventStatus · message · nickname · oilTemperature
Try the JMAK protocol devices on your own platform
Open the live demo or check the plans: white label, your domain, your apps.
Watch live demo · Configure my plan
Brands, logos and product images belong to their respective owners.