eelink protocol
TrackeraX decodes the eelink protocol on port 6064. These are the devices that use it, the data it reports and the commands you can send to them.
- Port
- 6064
- Models
- 37
- Brands
- 2
Devices that use eelink
- EELINK GOT08
- EELINK GOT10
- EELINK GPT06
- EELINK K6
- EELINK K9+
- EELINK TK115
- EELink TK319-H
- Eelink ET301
- Eelink G500M
- Goome Goome
- Goome GM06NW
- Eelink GPT06-3G
- Eelink GPT09
- Eelink GPT12
- Eelink GPT12-L
- Eelink GPT15
- Eelink GPT18
- Eelink GPT19
- Eelink GPT19-H
- Eelink GPT26
- Eelink GPT46
- Eelink GPT46-T
- Eelink GPT49
- Eelink K20
- Eelink K30
- Eelink TK116
- Eelink TK119
- Eelink TK119-3G
- Eelink TK119-T
- Eelink TK121
- Eelink TK121-S
- Eelink TK319-L
- Eelink TK418
- Eelink TK418-S
- Eelink TK419
- Eelink TK419-4G
- Eelink WTR1-T
Commands you can send from TrackeraX
Available from the web platform and the apps. The custom command sends any text the device firmware accepts.
- Request position
positionSingle - Engine stop
engineStop - Engine resume
engineResume - Reboot device
rebootDevice - Custom command
custom
Data reported by the eelink protocol
Parameters the server decodes from this protocol. In TrackeraX you turn them into sensors, alerts and reports. Each model reports the ones its firmware and wiring allow.
- Armed
armed - Battery voltage
battery - Blocked
blocked - Charging
charge - Fuel
fuel - Fuel consumption
fuelConsumption - GPS status
gps - Humidity
humidity - Ignition
ignition - Motion
motion - Odometer
odometer - GSM signal
rssi - Satellites
sat - Steps
steps
Numbered inputs and sensors
- Analog inputs (adc1, adc2…)
- Temperature sensors (temp1, temp2…)
Alarms the protocol can report
- Accident
accident - Fall
fallDown - Geofence entry
geofenceEnter - Geofence exit
geofenceExit - GPS antenna cut
gpsAntennaCut - Low battery
lowBattery - Low speed
lowspeed - Overspeed
overspeed - Power off
powerOff - Removal
removing - SOS
sos - Vibration
vibration
Protocol-specific attributes
co2 · illuminance · tag