jt600 protocol
TrackeraX decodes the jt600 protocol on port 6014. These are the devices that use it, the data it reports and the commands you can send to them.
- Port
- 6014
- Models
- 30
- Brands
- 2
Devices that use jt600
- JT GP4000
- JT GP5000
- JT GP6000
- Jointech GP4000
- Jointech GP4000A
- Jointech GP5000
- Jointech GP6000 (F)
- Jointech JT301A
- Jointech JT301B
- Jointech JT600
- Jointech JT600C
- Jointech JT701
- Jointech JT701D
- Jointech JT701T
- Jointech JT702
- Jointech JT704
- Jointech JT705
- Jointech JT705A
- Jointech JT705C
- Jointech JT706
- Jointech JT707
- Jointech JT707A
- Jointech JT709A
- JT JT600
- JT JT700
- JT JT700A
- JT JT700B
- JT JT700C
- JT JT701
- Jointech JT704A
Commands you can send from TrackeraX
Available from the web platform and the apps. The custom command sends any text the device firmware accepts.
- Engine stop
engineStop - Engine resume
engineResume - Set time zone
setTimezone - Reboot device
rebootDevice - Custom command
custom
Data reported by the jt600 protocol
Parameters the server decodes from this protocol. In TrackeraX you turn them into sensors, alerts and reports. Each model reports the ones its firmware and wiring allow.
- Battery level
batteryLevel - Blocked
blocked - Charging
charge - Door
door - Driver ID (RFID / iButton)
driverUniqueId - Fuel
fuel - GPS status
gps - Humidity
humidity - Ignition
ignition - Odometer
odometer - External power
power - GSM signal
rssi - Satellites
sat
Numbered inputs and sensors
- Temperature sensors (temp1, temp2…)
Alarms the protocol can report
- Fatigue driving
fatigueDriving - Fault
fault - Geofence entry
geofenceEnter - Geofence exit
geofenceExit - GPS antenna cut
gpsAntennaCut - Low battery
lowBattery - Overspeed
overspeed - Power cut
powerCut - SOS
sos - Towing
tow - Vibration
vibration
Protocol-specific attributes
alertType · backCap · eventSource · fuel1 · fuel2 · fuel3 · lbs · sensorBattery · sensorBatteryLevel · sensorRssi · steelCable