Harsh cornering sensor
Harsh-cornering event detected by the accelerometer of the device. Counts in driving-behaviour reports.
How to set it up in TrackeraX
- Open the device in TrackeraX and add a sensor of type “Harsh cornering”.
- Pick the parameter the device sends for it, for example hardCornering.
- Adjust the options below (unit, formula, calibration…) and save.
- The value shows on the map, in history, charts and reports, and you can use it in alerts.
Sensor options in TrackeraX
- Charts
add_to_graph - History
add_to_history - Map widget
add_to_widgets - Bit extraction
bitcut - On / off values
logic_on
Device data it uses
- Harsh cornering
alarm
GPS protocols that send this data
Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.
- gt06 — Port 6023 · 249 models
- teltonika — Port 6027 · 182 models
- gl200 — Port 6004 · 146 models
- jt808 — Port 6015 · 93 models
- meitrack — Port 6020 · 59 models
- dmt — Port 6137 · 49 models
- atrack — Port 6044 · 43 models
- castel — Port 6086 · 31 models
- megastek — Port 6024 · 31 models
- khd — Port 6058 · 25 models
- taip — Port 6031 · 25 models
- startek — Port 6222 · 16 models
- t800x — Port 6094 · 14 models
- huasheng — Port 6111 · 12 models
- hyn600 — Port 6258 · 12 models
- gator — Port 6052 · 8 models
- ivt401 — Port 6153 · 5 models
- flespi — Port 6149 · 3 models
- its — Port 6179 · 3 models
- owntracks — Port 6144 · 3 models
- nyitech — Port 6182 · 2 models
- sabertek — Port 6166 · 2 models
- gt06qze — Port 7024 · 1 models
- its2 — Port 6301 · 1 models
- sprint3x — Port 8023 · 1 models
- teltonika2 — Port 7028 · 1 models