Fuel consumption sensor

Fuel used, as reported by the CAN bus or the device. It can be read as an incremental counter or as separate values.

How to set it up in TrackeraX

  1. Open the device in TrackeraX and add a sensor of type “Fuel consumption”.
  2. Pick the parameter the device sends for it, for example fuelConsumption.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

Ways to read it

  • Incremental counter incremental
  • Separate values separate

Sensor options in TrackeraX

  • Charts add_to_graph
  • History add_to_history
  • Map widget add_to_widgets
  • Formula formula
  • Ignore empty values skip_empty
  • Unit unit

Device data it uses

  • Fuel consumption fuelConsumption
  • Fuel used fuelUsed

GPS protocols that send this data

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

All sensors

Watch live demo · Configure my plan