Fuel consumption sensor
Fuel used, as reported by the CAN bus or the device. It can be read as an incremental counter or as separate values.
[ How to set it up in TrackeraX ]
- Open the device in TrackeraX and add a sensor of type “Fuel consumption”.
- Pick the parameter the device sends for it, for example fuelConsumption.
- Adjust the options below (unit, formula, calibration…) and save.
- The value shows on the map, in history, charts and reports, and you can use it in alerts.
[ Ways to read it ]
- Incremental counterincremental
- Separate valuesseparate
[ Sensor options in TrackeraX ]
- Chartsadd_to_graph
- Historyadd_to_history
- Map widgetadd_to_widgets
- Formulaformula
- Ignore empty valuesskip_empty
- Unitunit
[ Device data it uses ]
- Fuel consumptionfuelConsumption
- Fuel usedfuelUsed
[ GPS protocols that send this data ]
Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.
- gt06249 models
- teltonika182 models
- gl200146 models
- jt808105 models
- meiligao71 models
- meitrack59 models
- t800x46 models
- atrack43 models
- navis39 models
- eelink37 models
- ruptela35 models
- castel31 models
- totem31 models
- xirgo31 models
- gps10329 models
- taip26 models
- mta620 models
- astra19 models
- ulbotech17 models
- startek16 models
- intellitrac14 models
- iotm13 models
- huasheng12 models
- bce11 models
- aplicom10 models
- arnavi7 models
- easytrack7 models
- vt2004 models
- autotrack3 models
- jmak3 models
- nyitech2 models
- pacifictrack2 models
- easytrackplus1 models
- gt06qze1 models
- ruptela21 models
- sprint3x1 models
- teltonika21 models