[ GPS sensor ]

Fuel level sensor

Reads the fuel in the tank from a float or capacitive probe, the CAN bus or the device itself. With calibration and the full-tank value, TrackeraX turns it into liters and shows refuels and drains.

Fuel level

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “Fuel level”.
  2. Pick the parameter the device sends for it, for example fuel.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Sensor options in TrackeraX ]

  • Chartsadd_to_graph
  • Historyadd_to_history
  • Map widgetadd_to_widgets
  • Calibration tablecalibration
  • Formulaformula
  • Full tank valuefull_tank
  • Ignore empty valuesskip_empty
  • Unitunit

[ Device data it uses ]

  • Fuelfuel
  • Fuel levelfuelLevel
  • Fuel leakalarm

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]